E010 option missing under MJXq

I just wrapped up modding my 7E with the 3 in 1 module. I followed the pin out from , but made a few changes. I gave up on the pin 13 onto the ARM chip, wanting to avoid damage so I moved the 2041 pin to were the 7105 chip was supposed to be connected. I changed the pins on the hardware.ini file to match. (enable-nrf24101 = A13) Now I'm booting up and getting no missing module errors. I'm able to get to the MJXq protocol and the sub selection, but E010 is not listed.

Did I do something wrong? Can the 2041 select pin not be put where I put it? Something wrong about the hardware.ini file? Simply missing the E010 model for some reason?

I should specify that I am using the v5.0.0 main release. Not a nightly build. I'll try a nightly build later this evening and see if it isn't just a version issue.

i think your right on your second post,
i am runnung a newish nightly build and the option is there..
Good luck

Hello!!

pin 13 onto the ARM chip
enable-nrf24101 = A13⇒A15

try!!

micro heli club wrote: Hello!!

pin 13 onto the ARM chip
enable-nrf24101 = A13⇒A15

try!!

I gave up on the pin 13, not wanting to damage it. So I put the 2401 select pin to where the 7105 went (pin 9 in the labeled images). I'm imaging there isn't any difference between these pins. They are presumably simple digital writes to define what chip is selected. Am I incorrect?

Problem solved. The most recent nightly build did the trick. I was able to bind straight away and I am business.

Please tell me how you fix this. I have the same problem. E010 format from MJXq is missing

E010 support was not available at the time of the standard 5.0.0 release (May 2016)
You'll need to install a newer build, such as this one, from May of 2017:

www.deviationtx.com/forum/builds/6407-de...cols?start=200#62154