Please help me run Mcp x 2!

I set myself here this firmware www.deviationtx.com/forum/model-configs/860-blade-mcp-x bind when the helicopter he just blink blue sticks, you can press the blade to react. But that's no gas. blades are not spinning!
Help please!

my mcpx works with no problems !

try this:

1. turn off the transmitter
2. attach battery on heli
3. wait till the blue leds are flashing
4. turn on the transmitter
5. in the settings press bind, wait ...
till the blue leds stop flashing
6. detach the battery from heli
7. turn off the tranmitter
8. attach the battery on heli
9. turn on the transmitter

Hope the heli will bind now !

cheers
graziano

Sorry a correction !


step 1-7 are o.k.

8 turn on the transmitter
9 attach the battery on heli

o.k.
try this config file

EXPO/DR for AIL and ELEV are on switch RUDD DR
Flight Mode: F0 indoor F1 outdoor (3D)

cheers
Graziano

for the MCPX V2 you have to hold the rudder stick to the right while binding. This sets the heli into computer transmitter mode... .

When a bind right pressed and worked! Thank you very much really helped everyone who unsubscribed!

For me too. Thanks a lot for binding after 2 days. For newbies it is important to say that if you use Tx with mode 2, like me in Germany, the rudder is the left stick of the two! That was my fault earlier...
Have a nice day !!!!