cc2500

can you take a picture of your module install? what does your hardware.ini contain?

I've looked over your images and don't see any issues. Have you checked the connections with a multimeter? I hate to ask, but you do have an antenna for the cc2500, right? You know the binding procedure for the D4Rii? I seem to recall these having an odd binding mechanism. I will go double check that the protocol still works on my module. Haven't tested it for a while.

I just checked with my D6FR, and it bound right up. My radio isn't using the same module you are though. have you tried the old wiring scheme (pin 9 tied to 3.3V and pin10 to gnd I think)? it shouldn't be necessary, but it might help.
What binding procedure are you using exactly? Deviation doesn't bind in quite the same way the official Tx does. Also, you aren't getting any errors about the CC2500 not being available, are you? if not, the cc2500 must be detected, and should be working. You don't see an '*' next to the Frsky protocol do you?

My bind procedure is:
Turn on Deviation Transmitter
Set protocol to Frsky
Make sure Telemetry is off (just to be sure)
Set Fixed ID to 123456
turn on the Rx while holding the bind button down (get dual flashing lights)
press 'bind' button on the Model menu.
wait for bind menu to go away
turn off rx
turn off tx

try hardwiring the module 9 and 10 pins to power and ground and see if it helps 1st.