CX10-C camera button captures

Hi all,

My cx10-c flies great with the cx-10 blue-A protocol, I just cannot figure out how to control the camera with my devo 7e. As I understand it the specific control has not been implemented yet in the protocol.

I have made three spi captures on the stock transmitter with my new logic analyser :

- binding of cx10-c to stock transmitter
- 3 times pressing the camera button (takes a snapshot to sd card)
- 4 times pressing the video button (alternately starts and stops the video recording)

the files are here : drive.google.com/file/d/0Bxf-446WD7Euand...OVE/view?usp=sharing

I do not have the skill to figure the protocol out but hope that someone can use these files.
Please note that is the first time using this logic analyser so if something is wrong please let me know.

Please export from the SPI decoder. The csv file should look like

Thanks for the feedback, just re-exported the files and also added the .logicdata saved files.

The files are here : drive.google.com/file/d/0Bxf-446WD7EuZVp...TUE/view?usp=sharing

wow, that's fast.

I will test it tonight and report back.

hi goebish,

just tested your build, set the protocol to type C and assigned channel 7 and 8 to a switch
- video on channel 8 works great it works both for toggling video on/off if pressed for a short time or it will record as long as the button is pressed for a longer time and stops when you let go.
- snapshot on channel 7 does not seem to do anything unfortunately...

Now the snapshot works as well, nice job! It does seem to lvc sooner but that just might be from all the testing

I will fully charge the quad and check once more

Correct, just tested it and it still does 2:30 - 3:00 of continuous video from full to flashing from low voltage (which also stops the video recording). That's the same as with stock tx.

thanks a lot !

Hi, just updated and set the protocol to blue-a, the quad flies but ch 7 and 8 do not seem to do anything anymore

Cool, now it works as before. Thanks !