I setup tri-rates on a 3pos switch (50/75/100) and put channel 5 (flips) on a momentary switch. Channel 5 will trigger flips if the pitch/roll input weight is 60 or higher, so in my low rate (50) the flip switch has no effect. The only hiccup so far is if I trigger flips in low rate it won't flip; however, if I then switch up to 75 or 100 the very first pitch/roll input will execute that pending flip that didn't happen while at 50.
The 001A's control board holds the 'pending flip' for longer than 60 seconds, not sure if it ever times out and resets. However, if you drop throttle to zero it will cancel the pending flip request (so landing or a mid-air drop/recover can reset the triggered flip input).
