WALKERA QR X350Pro - Adding a SERVO

More
28 Sep 2014 05:02 #25840 by docbaliman
WALKERA QR X350Pro - Adding a SERVO was created by docbaliman
Hi There!! , hope u can help me!! i need help installing a simple and common micro servo to my walkera qrx350 pro. im trying to install a hand-Made parachute system, and i need to add a servo mechanism in order to make The parachute open!

I have The devo F7 controller, and The DEVO-RX703A receiver...

how can i use the AUX2, AUX3, AUX4 or AUX6 to make the servo work (AUX1 and AUX5 are ocuppied with the 2d gimble pit and roll)....
on the devoF7 i have "free to use" the GEAR, D/R and HOLD/TRN switch....

can you please give me a hand?
THANKS!!
Mostrar menos

Please Log in or Create an account to join the conversation.

More
28 Sep 2014 09:13 #25846 by jesmail
Replied by jesmail on topic WALKERA QR X350Pro - Adding a SERVO
I suspect you need more channels in the transmitter to do that.
The F7 is 7 channels and it takes 5 channels for the Quad control and 2 channels for the Gimble. Need a Devo 10. The receiver is fine it actually can handle 11 channels.

Please Log in or Create an account to join the conversation.

Time to create page: 0.034 seconds
Powered by Kunena Forum