DEVO 12 problem

Hi,
I have problem with my transmitter - DEVO 12, I set on my transmitter on Throttle stick = 0, and when i start my transmitter, it say "Warning Throttle Stick" and i dont get EXT etc.

Please advise me what to do, Thank very much.

This is a Safety warning (not the safety feature of the throttle channel). Check your mixer to make sure the channels are in the right order - that the throttle stick is actually going to the throttle channel.

If that's the case, then you'll need to mount the Tx as a USB drive, edit the model file (don't use Notepad on windows, but Notepad++ is ok. Not sure what else is broken on Windows, but everything on a Mac, Linux or Unix system works fine), and find the [Safety] section where it says "Auto=min" and change it to say Ch#=min, where the # is the channel number your throttle is on.

I make this problem so:
In run transmitter i set minimum throttle ( Warning throttle stick ) at ZERO
I shutdown transmitter
I start transmitter and this problem has been created

Transmitter is not now run and no connect with PC

See photo scontent-cdg2-1.xx.fbcdn.net/hphotos-xft...880a30ec&oe=557BDA16

FDR wrote: So you are using the stock Walkera firmware.

Ensure that the flight mode switch is in the normal position.
If it doesn't solve the issue, than you are probably in the wrong mode, so try to lower the elevator stick to minimum.
If that helps check which mode is set in the transmitter...

here is my problem..

FDR wrote: Yes, I understood the same.

Have you tried to lower the elevator stick too as I had suggested?

Yes exactly, what should I do please? :/.. Throttle

FDR wrote: Just do the same with the right stick (the elevator), as you did with the left stick (the throttle).
The reason is that if the transmitter is in Mode 1 after the upgrade, the right stick is the throttle, which is in middle position...
The other possible reason is if your flight mode switch is not in the "normal" position, because then the throttle value is not at the minimum, so scheck the FMODE switch also...

I do not understand you can not do video please? :/
I can not enter into the menu, I have here a warning throttle and get started, exit deal, krizek the display can not be pushed

FDR wrote: Prostě udělat to samé s pravou páčkou (výtah), jak jste to udělali s levou tyč (plyn) .v důvodem je, že v případě, že vysílač je v režimu 1, po upgradu, pravá hůl je plyn, který je v middle pozice ... druhý možný důvod je, pokud váš přepínač režimu letu není v

(Google translate is my friend... )

I tried to understand it but I do not understand this

FDR wrote: Sorry, but I can't explain it any simpler...

No change..

dump