Hubsan X4 config

goebish wrote:

sbstnp wrote: Naughty build LOL

auto correct wreck

I guess thibaut is French, I'm too, everybody knows we're bad at english

Hihi, absolutely not true, my friend Philippe speaks a very good English

Does the latest nightly build support the additional channels for the X4 v2?

HeliBen wrote: Does the latest nightly build support the additional channels for the X4 v2?

It does now.

If you have a 7E this model file is a good place to start:

I just bought the module for my Devo10 A7105-500m.
Can the hubsan X4 V2 100% be enjoyed with deViation with no problems? Thanks!

I have the latest 3.0 official version.

goebish wrote: X4 V2 is 100% supported, but only in the nightly release.

Thanks. Is the installation of the nightly build like the installation of a standard new official relase?

Where can I get it? Thanks again.

is this the correct last updated ini file?

www.deviationtx.com/forum/model-configs/...art=0&start=20#12590

perfect, I have a wonderful devo 10

Are you an engineer that have you been able to hack the hubsan protocol? What's your background?

goebish,
Could you take a photo of how it looks like when you have your analyzer hooked up? I just got the same one you have from [url=http://www.banggood.com/USB-Saleae-24M-8CH-24MHz-8Channel-Logic-Analyzer-Latest-Support-1_1_15-p-74101.html?p=5@1023051690201202T8]BangGood for a cheap $8.50[/url] and need some guidance to get started.

I believe it's still fresh on your mind.

Thanks in adavance.

-Daryoon

Hi, I just installed my A7105 module in my Devo 10 and with your config file everything works fine!! Thanks!!

If I turn on the transmitter then the hubsan it doesn't auto bind. If I go in the setup menu end push reinit it binds fine!

This happens to you?

I would like to have a description for your config file.

GEAR 1 lights OFF
RUD DR 1 for trotthle hold
fm0 low rate
fm1 high rate?
fm2?

There is the no flip function?

mix0/1/2 activated?

Thanks!

matrixFLYER wrote: Hi, I just installed my A7105 module in my Devo 10 and with your config file everything works fine!! Thanks!!

If I turn on the transmitter then the hubsan it doesn't auto bind. If I go in the setup menu end push reinit it binds fine!

This happens to you?

I would like to have a description for your config file.

GEAR 1 lights OFF
RUD DR 1 for trotthle hold
fm0 low rate
fm1 high rate?
fm2?

There is the no flip function?

mix0/1/2 activated?

Thanks!

Ok I understood it by myself...the only thing that I do not understand is how is the autoflip prevented in FMOD1??? I don't understand if it's just the aileron/elevator throws or it's something else.

By default the setting of the model is 4 channel but it uses gear channel to turn on off the light so i changed to 5 channel but in the official deviation documentation is written that only 4 channel are supported for hubsan protocol. I don't understand...i need someone to clarify this thing.

Furthermore I tried to lower the TX power output to 1uW (microW): look like that isnt' lowered like it is on my other dsm2 receiver. I can go very far and still have control. Does TX output in deViation works with the Hubsan protocol??

Thanks, perfect!