CX 10D Traces

I really appreciate your hard work to implement protocols you don't even use, that's one of the reasons I bought a logic analyzer so I can give back and help the community that has helped me.

In my remote the XN297 was on a small daughter board that had only like 6 connections, so I just dumped all of them. Cannot check anymore because I throw away my remote.

gist.github.com/schwabe/9e8563f1abecbee4...ghter_board_cx10-jpg

ok yeah that's very different to mine, I got the pins mapped to the bigger IC and will solder jumpers tonight. Is there any special mode in Logic that I'm supposed to capture on, or is it just a case of turning on the TX and saving what goes through pins 1-4?

Hopefully I did this right, there's a settings mismatch error at the beginning that I couldn't get rid of

Well, this project just ended abruptly as I somehow managed to remove one of the legs from the "big" IC and now the Tx won't work at all (power light just flashes, no beep). Unfortunately that means there's now no chance of my CX10 ever flying again, since my Devo won't bind with it and I don't have the original Tx to use (and I'm out the cost of the logic analyzer). Not a good day...

as much as I hate to spend more money, this board looks identical (except for the build date) - www.ebay.com/itm/Cheerson-CX-10WD-CX10WD...9:g:ORgAAOSwYXVY0Dsa

edit : nevermind, not identical

Hi,

I have several little drones (tozo, drocon, visuo, etc) and i started to modify my devo12s with deviation.
I paired with success a CX10 blue version, but i have no success with the others.
I started to look deeper with a CX10D. As i'm unable to bind it, i suppose that maybe the one i have use a slightly different protocol.

I solder required pins on my remote and connected to a fx2 usb chip.
Then i used sigrock la to capture datas.
Datas seems correct, but i don't know what to do with it.

The only things i found are (if i'm not wrong):
ID : BE 5F 34 12
TX: 2B 14 28 40 25 3D 22 3D 22 3A 1F 37 1C 34 19 31 16 2E -> 24Mhz

Sigrock software analyze datas, but does not seem to export analysed data.
It can export captured data in VCD format, can it help ?

I'm really interested in understanding how it works and in changing all my remote by the devo.

Regards

What is the proper button to launch the quad on the devo 7e? I can bind but unable to do anything else. I tried the trim buttons on the transmitter.

I`ve just tried to binf my CX-10D with Devo 7E using the protocol Q303 with both CX10 and CX10W variants with no success. I`ve used nightly build cc06d0 firmware instead the test builds avaiable in this thread.

The quad`s lights remains blinking quickly meaning no binding. Is there some bind procedure diferent to do that rather than just switch on the model and then pressing the button "bind" on transmitter?

Or Should I prefer try the test build avaiable in this thread instead the newer nightly build?

plaisthos wrote: In my remote the XN297 was on a small daughter board that had only like 6 connections, so I just dumped all of them. Cannot check anymore because I throw away my remote.

gist.github.com/schwabe/9e8563f1abecbee4...ghter_board_cx10-jpg

My stock receiver is simmilar i showed by @plaisthos, except the code printed on board is JG-CX1011TX-4