Mjx Bugs 3

I'm not getting a fixed id on a bugs 3 mini.

The Black and Silver

ok so i have it on the black and silver model I can get a fixed id number and have tryed it on 2 diff bugs 3s I have both come up with a negitive fixed id number and the toggles wont do anything any sugjestions please

UPDATE got it situated I have it bound to the mjx bugs drocon 3 as well as a 1st gen bugs 3 will be binding to many others I have a full line up of them

ok I have bugs on the jumper thank you -- is there any wat to increase the pitching as it seems to be same or less than stock controller -- or is it possable to create a new file to put on t8sg for much greater pitching SAY a turbo bugs 3 protocol -- ??

In a previous post hexfet decided to not work on different speed modes (at least in the current state of development), that can be handled in the mixer. Those some weeks while hexfet returns to bugs 3 protocol development is a good opportunity to gather possible problems of the current implementation from the testers.

the drone flys well but i think added speed or pitch values would be nice -- sure i tryed 125% and just didnt seem to pick up that much pitching idk

Hi Guys,
My original Bugs 6 binds using the Bugs3 protocol. Turns out I made a transcription error entering the Tx ID with an earlier build.
I detected this using the auto lookup version.
Jaydrone has just put up a video demonstration that the new Bugs 8 Pro will also bind with the Bugs3 protocol.
Getting more useful every day ....

yes the bugs 8 pro i just put on it -- I did hover test works well the lvc on the drone also works on the drone as to be expected and loss of connection from t8sg alarm will also sound i will do flight video in some time

If it's working on all these other versions am I doing something wrong on the bugs 3 mini?

Does anyone know Where do I solder the jumper wire to take captures for the bugs 3 mini?

no ur not the mini and the bugs 3h are not on the same protocol and wil not work with the t8sg off of this dfu file

I'm trying to find the ground to solder the rest of the jumper wires to take captures of the b3 mini but I can't find the ground,if anybody can find the ground from the pics by the RF chip traces,can you please mark it in the photo,thanks in advance.

Right where it says GND.

Thanks but that wasn't it,that's the ground for the battery.I found it using the multimeter and will u pload the captures later.

Wow,I never knew that,thanks appreciate it.

I just took this capture of the b3 mini bind sequence,would like to know if it's good so I can proceed with the captures,if anyone with experience in reading captures look at them it will be greatly appreciated.
www.mediafire.com/file/kw0tkodqbtrv622/T...0on%20Bind.logicdata

Can't download from that link. Clicking the green button opens a pop-under and never starts a download. If you put it in a .zip you can probably upload it here.

For the control travel we can revisit the driven trims and see if the problem is just wrong directions. Someone please post a bugs3 model file so I can see which channels are reversed.

mmakai, nice work on the rxid mapping. Not sure what's best for the memory requirement. Probably okay if it's just not added to the limited-memory builds.